after being a little to rough to my LCD-screen while removing spilled resin, I had to change it to a replacement one. The new one has some issues, it does not light up the whole buildung area, about 10mm on each side stay dark and there is a strange flickering, rectangle shaped areas, maybe 10mm in width over the full visible height black out for a short but noticeable time.
It is hard to capture on my cellphone but in the upper right corner you can see some of the blackout artefacts and the flickering is visible too.
But after recording this video, it doesn't look as bad as in reality, maybe the issue is at a constant frequency wich is close to or a multiple of the recorded fps?
Can anyone tell me, how I can fix this issue? Best regards,